Standard equipment
- HtCeramic controller (20 programmes with 15 steps each)
- SiC plate at bottom of furnace
- heating spirals made from Kanthal APM (only for furnaces for temperatures of 1400 °C)
- Alsint ceramic tubes (only for furnaces for temperatures of 1400 °C)
- stand for K 50 through K 300
- slide valve for controlling air intake at the bottom of the furnace
- ventilation bleeder (K 50 – K 300)
- manually controlled ventilation flap (K 500 – K 2000)
- power supply cable (K 50/13 – K 300/13 and K 120/14 – K 300/14)
- door opening towards the left
- limit switch for safe opening of the furnace
Optional accessories available at additional cost
- HtIndustry/Ht205 controller (30 programmes with 15 steps each)
- multi-zone heating system (K 500 – K 2000)
- heating spirals made from Kanthal APM (for furnaces for temperatures of 1300 °C)
- Alsint ceramic tubes (for furnaces for temperatures of 1300 °C)
- manually controlled ventilation flap (K 50 – K 300)
- automatic ventilation flap
- graphic temperature recorder (for the K 50 through K 300, the controller and recorder are located in a small switchboard on the side of the furnace)
- calibration of the controller’s measuring input
- RS232 or EIA485 calibration (not possible with HtCeramic controller)
- HtMonit set (software + interface; not possible with HtCeramic controller)
- overpressure forced cooling
- custom stand for K 50 through K 300
- door opening towards the right
Note: When combining accessories (at additional cost), consult with our technical office. When combining at least two accessories (automatic ventilation flap, overpressure forced cooling, graphic temperature recorder), an HtIndustry/Ht 205 controller is needed.